Mega Man 8-bit Deathmatch > Tutorial Collection

[TUTORIAL] Creating a customized skin

<< < (7/9) > >>

Ruzma:
Did you guys set each individual frame as Monster (GL-friendly) and then saved it? Name them correctly, like XXXXA6A4 and whatnot?

Poker Okami:

--- Quote from: Ruzma on January 16, 2020, 04:07:52 PM ---Did you guys set each individual frame as Monster (GL-friendly) and then saved it? Name them correctly, like XXXXA6A4 and whatnot?

--- End quote ---
Set as Monster (GL-friendly) : yes
Saved : yes
Named : yes

did follow all the instruction  :confused:

Ruzma:
So, you did compile the necessary frames into a folder, with the skin info, saved it as a PK3 file, into your skins folder...and yet it doesn't work?
That is most strange. You should try to do it again, as much of a pain as it is, if the instructions are followed to a tee, it'll work. It worked for me, I just made me a skin, so it's good.

Poker Okami:

--- Quote from: Ruzma on January 17, 2020, 07:00:15 PM ---So, you did compile the necessary frames into a folder, with the skin info, saved it as a PK3 file, into your skins folder...and yet it doesn't work?
That is most strange. You should try to do it again, as much of a pain as it is, if the instructions are followed to a tee, it'll work. It worked for me, I just made me a skin, so it's good.

--- End quote ---
I just noticed i forgot to put the 4 digit for the sprite and forgot to remove the "x" between the number.
And now it's say's that i got an error of "Bad Frame" and also it's say's that the frame A is missing rotations... what should i do?

Ruzma:
For example, my skin for my little character, Edgeward has every frame start with EDGE.
Therefore, the front idle frame would be named EDGEA1. The front-side idle frame would be EDGEA8A2, so on and so forth (don't mind the bold, it's just for clarity's sake).
Make sure that you have idle frames for front, back, back-right, side and front-right, ok? Then do the same, but four times over for the walk frames, again, from all sides.
Same thing again for the shooting frames, of which there are only two. If you want, you can an (in)visible corpse frame by setting it up as XXXXZ0 (it's a Zero, btw).
By all means, it should be all good! Don't lose hope, it worked for me just a few days ago, you simply have to be reeeaaaally careful with the naming and all. Just check every single one.

I...hope this is useful, somehow.

Navigation

[0] Message Index

[#] Next page

[*] Previous page